NUMERICAL STUDY OF THE INFLUENCE OF INJECTION MODES ON THE STRUCTURE OF TURBULENT FLAME OF LIQUID HYDROCARBONS IN THE CYLINDRICAL COMBUSTION CHAMBER

Authors

DOI:

https://doi.org/10.26577/ijmph.20211326

Abstract

Abstract. The influence of initial injection velocity on turbulent spray combustion of n-dodecane (C₁₂H₂₆) and n-octane (C₈H₁₈) in a model cylindrical chamber was investigated numerically. An Eulerian–Lagrangian approach was used to describe the compressible gas phase and dispersed fuel droplets. The gas-phase conservation equations were coupled with the standard k–ε turbulence model, while droplet breakup and evaporation were described using the Taylor Analogy Breakup model and a diffusion-controlled evaporation model. Injection velocities ranged from 80 to 300 m/s. For n-dodecane, the reported maximum gas temperature was 2200 K at 80 and 100 m/s and 2400 K at all sampled velocities from 150 to 300 m/s. For n-octane, the maximum temperature remained at 2400 K across the sampled velocities at the reported precision. The maximum CO₂ mass fraction was 0.150 for both fuels. The maximum H₂O mass fraction increased from 0.065 to 0.070 for n-dodecane and remained at 0.070 for n-octane. Thus, 150 m/s was the lowest sampled injection velocity at which the reported temperature maxima of the two fuels coincided. The results characterize the sensitivity of local temperature and product mass-fraction maxima to injection velocity and provide a basis for selecting operating conditions for further model validation.

Keywords: spray combustion, numerical modeling, injection velocity, n-dodecane, n-octane.

Downloads

Published

2026-11-20

How to Cite

NUMERICAL STUDY OF THE INFLUENCE OF INJECTION MODES ON THE STRUCTURE OF TURBULENT FLAME OF LIQUID HYDROCARBONS IN THE CYLINDRICAL COMBUSTION CHAMBER. (2026). International Journal of Mathematics and Physics, 17(2), 30-41. https://doi.org/10.26577/ijmph.20211326